Carrier 69NT40-541-306, Операция и обслуживание

Страница: 130 / 154

T-354 7–42
Materials needed:
1. Cut two square pieces of 3mm thick (1/8-inch) aluminum or stainless steel approximately 40mm (1- 5/8”)
square. These squares will serve as backing plates.
2. Two nuts, bolts (10-24 x 1") and washers for each insert that needs repair.
a. Drill a 1/4” hole in the center of each square backing plate.
b. Pass the bolts through the bolts holes in the door hinge, then through the control box at the location
where the hinge insert pulled out.
c. From inside the control box, slide the backing plates over the bolts and secure in place with the washers
and nuts.
Figure 7.33 Door Hinge Repair
Table 7–2 Crack, Chip and Hole Repair Kit
ITEM DESCRIPTION PART NUMBER QTY
1 Crack Repair Kit - Includes 76-00724-00SV 1
2 Fiberglass Patch Kit (Loctite FK-98 or 80265) 76-00724-00Z 10
3 Sikaflex 221 Adhesive Sealant (Sikaflex 232-361) 02-00067-02Z 10
4 Instruction Sheet 98-02339-00 10