Carrier 50HC Series, Руководство по установке

Страница: 23 / 52

23
Connecting the Thermidistat device (33CS2PPRH-01)
1. Route the Thermidistat multi-conductor thermostat cable
(field-supplied) through the hole provided in the unit corner
post.
2. Feed wires through the raceway built into the corner post (see
Fig. 36 on page 20) to the 24-v barrier located on the left side
of the control box. The raceway provides the UL-required
clearance between high-voltage and low-voltage wiring.
3. The Thermidistat has dry contacts at terminals D1 and D2 for
dehumidification operation (see Fig. 46). The dry contacts
must be wired between CTB terminal R and the PINK lead to
the LTLO switch with field-supplied wire nuts. Refer to the
installation instructions included with the Carrier Edge ® Pro
Thermidistat device for more information.
CONTROL AND POWER WIRING DIAGRAMS
See Fig. 47-56.
Fig. 45 — Typical Humidi-MiZer Adaptive Dehumidification System Humidistat Wiring