40MPHB: Owner’s Manual
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
2
A NOTE ABOUT SAFETY
Any time you see this symbol
in manuals, instructions and on the unit,
be aware of the potential for personal injury.
There are 3 levels of
precaution
:
1.
DANGER
identifies the most serious hazards which will result in
severe personal injury or death.
2.
WARNING
signifies hazards that could result in personal injury
or death.
3.
CAUTION
is used to identify unsafe practices which could
result in minor personal injury or product and property damage.
NOTE
is used to highlight suggestions which will result in enhanced
installation, reliability, or operation.
GENERAL
The high wall fan coil unit provides quiet, maximum comfort. In
addition to cooling and/or heating, the high wall fan coil unit matched
with an outdoor condensing unit filters and dehumidifies the air in the
room to provide maximum comfort.
IMPORTANT:
The high wall fan coil unit should be installed by
authorized personnel only; using approved tubing and accessories. If
technical assistance, service or repair is needed, contact the installer.
The high wall fan coil unit can be set up and operated from the remote
control (provided).
If the remote is misplaced, the system can be
operated from the “Auto” setting on the unit.
Operating Modes
The high wall fan coil unit has five operating modes:
• FAN Only
• AUTO
• HEATING (heat pumps only)
• COOLING
• DEHUMIDIFICATION
FAN Only
In the
FAN Only
mode, the system filters and circulates the room air
without changing room air temperature.
AUTO
In the
AUTO
mode, the system automatically cools or heats the room
according to the user-selected set point.
NOTE: AUTO mode is recommended for use on single zone
applications ONLY. Using AUTO CHANGEOVER on
multi-zone applications could set an indoor unit to
STANDBY mode, indicated with two dashes (--) on the
display, which will turn off the indoor unit until all the
indoor units are in the same mode (COOLING or
HEATING). HEATING is the system's priority mode.
Simultaneous HEATING and COOLING is not allowed.
HEATING
In the
HEATING
mode, the system heats and filters the room air.
COOLING
In the
COOLING
mode, the system cools, dries and filters the room
air.
DEHUMIDIFICATION (DRY)
In the
DEHUMIDIFICATION
mode, the system dries, filters and
slightly cools the room air temperature. This mode prioritizes air
dehumidification but it does not take the place of a dehumidifier. This
feature cannot be used in a multi-zone system.
Wireless Remote Control
The remote control transmits commands to set up and operate the
system. The control has a window display panel that displays the
current system status. The control can be secured to a surface when
used with the mounting bracket provided.
Wired Remote Control (Optional)
Refer to the Wired Controller manual.
24V Interface (Optional)
Allows the control of the Ductless System with a third party thermostat.
Smartphone Control (Optional)
Capability to be controlled by a smartphone adding the Wi-Fi®
Interface Kit
KSAIF0601AAA.
PERSONAL INJURY, DEATH AND / OR PROPERTY
DAMAGE HAZARD
Failure to follow this warning could result in personal injury, death or
property damage.
Improper installation, adjustment, alteration, service, maintenance, or
use can cause explosion, fire, electrical shock, or other conditions
which may cause personal injury or property damage. Consult a
qualified installer, service agency, or your distributor or branch for
information or assistance. The qualified installer or service agency
must use factory-authorized kits or accessories when modifying this
product.
Read and follow all instructions and warnings, including labels
shipped with or attached to unit before operating your new air
conditioner.
WARNING
