Carrier 09PE, Инструкции по установке, эксплуатации и обслуживанию

Страница: 8 / 28

5.5 - Shipping
■ Follow the handling instructions affixed to the packages
■ Do not stand on the packages
■ Do not place anything on top of the packages
■ Strap the packages onto the deck of the truck
■ Only textile straps are authorised (lifting and coupling)
■ Use an open top for container shipping single-line machines, but use the option intended for this purpose for other machines.
6 - STORAGE
■ Store the units at a temperature of between -40 and +60°C (temperature range for standard units). For options, see the relevant
description.
■ Protect the units against impacts and ensure that they only support their own weight.
■ Place the units on firm, flat and level ground. For storage in very windy areas, affix the unit to the ground using straps or cables.
■ Leave the blanking trim for the pipes in place before connecting the unit.
■ For long-term storage (over 3 months), fill the exchanger with an inert gas and seal the pipes using caps. This is necessary to
prevent the formation of condensation and oxidation. Warning: do not exceed the maximum operating pressure indicated on the
data plate.
■ For long-term storage, it is recommended to place the units in an area protected from adverse weather conditions.
7 - INSTALLATION
■ Contact us for projects with a "special" seismic risk.
■ Before setting up the unit in its intended location, the installer must check the following points:
-
The unit must be installed outdoors in an area protected from flooding. Ensure that all conditions have been taken into account
(negative outdoor temperatures, corrosive atmosphere, altitude, etc.)
-
The ground surface or structure must be level and strong enough to bear the unit's weight.
-
Raise the unit if it is installed in a snowy area, in order to ensure a sufficient air intake height.
-
At the design stage, check that the installation location is compatible with the unit's sound level.
-
For vertical units, the flow of air crossing the unit must not be parallel to the prevailing wind.
-
Protect the unit from sandstorms using the appropriate infrastructure.
-
Waste from vegetation is a major factor contributing to the clogging of the coil; avoid installing the unit close to deciduous trees.
-
Do not install the unit near hot air extraction duct outlets.
7.1 - Maximum permitted wind speed
■ Maximum permitted speed: 100 Km/h.
■ For speeds > 100 Km/h, contact us.
5 - INSTRUCTIONS FOR LIFTING AND PLACING THE FEET IN THE OPERATING
POSITION AND FOR SHIPPING
8