Carrier TRANSICOLD VECTOR 8100, Руководство по эксплуатации и обслуживанию, Страница: 202 / 294

62-11785 7–64
02003 DISPLAY MODULE ERROR
• ACTIVATION: The APX Control system has detected 50 or more On/Off transitions of the SROS within a
4 minute period.
• UNIT CONTROL: Shutdown and Alarm.
• RESET CONDITION: The system can be temporarily reset by enabling Emergency Bypass Mode. The
system will be permanently reset after replacing the Display Module.
NOTE: Follow the steps below until a problem is found. Once a repair or correction has been made, the active
alarm should clear itself (refer to reset condition above). Operate the unit through the appropriate modes to see
if any active alarm occurs. Continue with the steps below as necessary.
CORRECTIVE ACTIONS:
1. Enable Emergency Bypass Mode - This is a temporary solution that will only allow the system to func-
tion for 24 hours.
a. In the event of an alarm caused by a failure of the display module, the unit will go into shutdown. In
order to temporarily bypass this shutdown state, Emergency Bypass Mode can be activated, refer to
Section 3.22 .
b. Once Emergency Bypass Mode has been activated, the unit will operate normally for 24 hours, a
countdown timer will be shown on the display. This 24 hour window of operation will keep the load
safe, and provide enough time to contact the nearest Carrier Transicold Service Center for repair of
the unit.
2. Remove and replace the Display Module, refer to Section 8.10.4 .