30
31
GB
GB
5. Charging
NOTES:
•
Prior to the first use
(without cable), charge the device
for approx. 8 hours.
•
With regular use
the time for a full battery charge is
approx. 8 hours.
• Please note that the battery capacity will decrease
during extended periods of storage. For this reason, long
recharging times should be avoided because of the inter-
ruption between the charging and discharging cycles.
1. Connect the wall power supply to the device.
2. Insert the wall power supply into an easily accessible
socket. The LED lights up. It stays lit as long as the
device is connected to the mains.
3. Put the device down with the front upwards.
4. After the wall power supply is disconnected, the LED
goes off. With a completely charged battery pack, the
device is able to operate for approx. 45 minutes.
6. Operation
Regardless of the charging state of the battery pack, you
are always able to use the hair trimmer with the power pack.
1. In order to use the power pack, ensure that the device is
switched off.
2. Connect the wall power supply to the hair trimmer.
3. Insert the wall power supply into an easily accessible
socket.
4. Use the on/off switch on the side to switch on the hair
trimmer.
Replacing/Adjusting the comb attachments
WARNING!
Switch off the device before replacing or changing the comb
attachments.
• Push on the comb attachment by carefully inserting
the guide arms of the comb attachment into the lateral
recesses of the device until it locks into place.
• Set the cutting length: use the control dial on the upper
side of the device to set the desired position of the comb
attachment. The device must be switched off during this
adjustment.
• To remove the comb attachment, first switch off the
device and then grasp the attachment by holding the two
guide arms with your thumb and pointer finger, and pull it
out off the lateral recesses.
Cutting hair
NOTES:
• The hair to be dressed must be dry.
• The cutting length may deviate depending on the cutting
angle.
• First, start with a comb attachment for a longer cutting
length and then, in the course of the cutting process, use
shorter cutting lengths step by step.
• Comb the hair well.
• Place a sheet or cape around throat and neck to prevent
cut-off hair from dropping into the collar.
• Start by cutting the hair in the neck or on the sides and
cut towards the centre of the head. Then, cut the front
section of the hair towards the centre of the head.
