ULW Czech, s.r.o.
V Ráji 34, Praha 9
-
Hostavice, 198 00, CZ, IČO: 28256212, DIČ: CZ28256212
8.5.
Protect the Device from heat sources that could cause the temperature inside the Device
exceed the operating parameters mentioned above.
8.6.
When stationary, protect the Device from direct sunshine, which can cause the internal
Device’s temperature
to rise well above the ambient temperature (remove it from the
Holder or cover it).
8.7.
Long term exposure to sunshine can cause LCD fading (such fading is not considered a
defect).
8.8.
While riding, protect the Device from direct airstream (position it behind a windscreen).
This is particularly important when the Device is used in wet conditions (e.g. rain)
–
at high
speeds the rain will create pressure
equal to jet water, which exceeds the Device’s
protection rating.
8.9.
Before you charge you
r vehicle’s battery
, always remove the Device from the Holder and
disconnect the M8 charging cable from the Device. If the Holder power source is connected
directly to the vehicle’s battery or “always on” auxiliary power outlet, t
he charger will
trigger the power source in the Holder, which could lead to problems with charging and
possibly harm the Device due to frequent power on/off condition created by pulses
generated by the charger.
8.10.
When the Device is not in use, power it off to prevent complete battery depletion. The
Device will power down automatically when the battery is close to depletion. Nevertheless,
the Device still consumes small amount of energy even when in OFF state, which could lead
to deep battery discharge, if the Device was powered down at low battery level or even
powered down automatically because of depleted battery. Battery will be damaged or
destroyed by deep discharge. To prevent battery damage, ensure that a depleted battery is
re-charged immediately to at least 50% capacity.
8.11.
If the Device is not in use for longer periods of time (more than 1 week), make sure the
battery is charged to at least 60% before it is powered down.
8.12.
Protect the charging mating pads on the back of the Device from touching electrically
conductive material / liquids or the Device might be short-circuited (and destroyed as
consequence).
9.
Carpe Iter Holder
9.1.
The Carpe Iter Holder is specifically designed for the Device. Do not use the Holder for any
other equipment than the Device.
9.2.
The Holder will ensure secure mounting and will also provide continuous charging for the
Device through the mating pads on the back on the Device.
9.3.
The Holder includes a power source that was designed specifically for the Device.
DO NOT
use the power source to power any other equipment than the Device
.
9.4.
Description:
