PRELIMINARY RELEASE
*** This is a confidential document. Do not distribute. ***
2.10.
RF Testing with RadioTest
Either on the bench or in the field, you can use the RadioTest software to test the RF
performance of the radio. This software will provide you with accurate measurement of the
signal-to-noise ratio (SNR), bit error rate (BER) and more.
2.10.1.
Minimum System Requirements
Use of the RadioTest software requires two IBM-compatible PCs with the following:
1 GHz processor
512 MB of RAM
Microsoft Windows 7 operating system
Microsoft .NET Framework 4.5
An Ethernet patch cable
2.10.2.
Download the RadioTest Software
You may obtain the RadioTest software from our website by following the link below:
http://www.carlsonwireless.com/applications/RadioTest/RadioTest.zip
This section of the manual is under development. Visit the Carlson
any questions.
3.
Installation
3.1.
Field Installation
3.1.1.
Professional Installers
RuralConnect® radios can only be installed by professionally trained personnel.
3.1.2.
Antenna height and RF exposure warnings
RuralConnect® installations must adhere to all local, state, and federal regulations. Failure to
follow those guidelines could result in costly fines, damage to the equipment, and/or inadequate
RF protection for end users. Per FCC regulations; antennas used with fixed TV Band devices
may not be more than 30 meters above ground level, or 250 meters above average terrain. All
persons are required to maintain at least a 40 cm distance from the device; additional hardware
may be required to ensure that separation. All regulatory compliance requirements related to the
installation and operation of
RuralConnect® devices are the
sole responsibility of the operator.
3.1.3.
Installing
RuralConnect® CPE
units
Most CPE installs will use pole
mounts for mounting
RuralConnect® Tower Top units
Page | 15
