CARLO GAVAZZI POWERSOFT, Инструкция по эксплуатации

Страница: 46 / 74

PowerSoft
PowerSoft – Instruction manual
46
5.4 S
ETPOINT CONFIGURATION
(PWS-A
LARM MODULE
)
This module allows the configuration, for each instrument connected and
for each one of the relevant variables, of an upper and/or lower setpoint/s.
To configure a setpoint, an instrument is to be selected first. The list of all
the connected instruments is available on the left. All the variables of the
selected instrument are listed in the central box. Two indicators are shown
close to each variable. The SW indicator shows if any software alarm
connected to that variable is enabled (green), disabled but configured (red),
or disabled and not configured (grey). The HW indicator shows if any
hardware alarm connected to that variable is enabled (green), or disabled
(red). If HW is enabled and in case of alarm, the digital output of the
relevant instrument (the first one, or the first one of slot D, in case of
modular instrument) is activated.
This output is to be set as “REM”
directly on the instrument .