Car Park 3 – General installation
9
3 Install the sensors
Notice:
during the planning, you must decide where and how to mount the sensors. You must
consider the following conditions:
• On the ceiling
• On a cable tray
• As a lowered sensor
When you install sensors, you should investigate what kind of technique is the best in that specific
installation.
Please evaluate the most properly sensor that fits the project requirements.
In most installations, the lane-mounted sensor will be preferred because of the reduced cost of labour
and material used. In some circumstances the vertical sensor is preferred, but that will be a decision
made by the owner and the architect of the building.
3.1 Install the SBPSUSL45 lane sensor
The SBPSUSL45 is a 45-degree angled sensor that should be placed in the driving lane,
outside each parking bay pointing towards the parking bay. Consider the following indications:
Height: 2.2 to 2.4m
Depth of detection: 1.5 m
Maximum vertical deviation:
±
5°
Maximum horizontal deviation:
±
2°
Side view
Top view
(the sensor is mounted in front of the parking bay)
