Microprocessor
Temperature Controls
EZ-Temp
TM
Instruction Manual
70 Maple Street
East Longmeadow, MA 01028
Ph 413-525-7700
Fx 413-525-8306
Carlin Combustion Technology, Inc.
T
ech
support
800-989-2275
carlincombustion.com
©
Copyright 2008 — Carlin Combustion Technology, Inc.
Installer/servicer
— Except where specifically stated otherwise,
this manual must be used only by a
qualified service technician
.
Read and follow all instructions in this manual and in the appliance
manual. Failure to comply with this or other requirements in this
manual could result in severe personal injury, death or substantial
property damage.
This symbol calls out a hazard that could cause severe personal
injury, death or substantial property damage if the instructions
given are not followed.
Wiring:
Refer to EZ-Temp data sheet for wiring information.
Verify ratings:
Verify the ratings of the control meet the require-
ments of the appliance as specified in the appliance instructions.
Refer to the EZ-Temp control data sheet for required electrical
supply and load ratings. Verify that the controls, wiring and instal-
lation comply with all applicable codes.
Electrical shock hazard:
Disconnect power to appliance when
wiring or servicing any electrical component.
Scald hazard:
Water hotter than 130°F can cause serious burns or
death. Follow water heating appliance manufacturer’s guidelines
when installing temperature limit controls - DO NOT install a control
that can be set at a higher temperature than specified. Also verify
that the installation includes all water temperature regulating
means needed to ensure the safety of building occupants, in
compliance with all applicable codes.
Verify operation:
Test the controls/appliance to verify the appliance
operates as specified in the appliance manual before leaving the
installation.
E-Clamp Style with red sensor retainer plug
