Carl Valentin COMPA II, Руководство по эксплуатации

Страница: 65 / 116

Compa II Options
03.20 Operating manual 65
7 Options
7.1 Cutter
CAUTION!
Risk of injury, particularly during maintenance, the cutter
blades are sharp!

Switch off the printer before attaching the cutter!

The cutter may only be used when it is mounted on
the printer!

Do not try to cut any materials which exceed the
maximum width or thickness specifications.

Do NOT touch the area of the moving blades!
Switch on the label printer and the display shows the main menu.
Press the key to access the function menu.
Press the key until the menu Cutter is displayed.
Press the key to select the menu.
NOTICE!
The menu item cutter is only displayed if the printer recognizes
the option via cutter photocell when switching on the printer.
In the upper line of display, the cutter mode can be selected.
In the line below, the cutter offset (approx. 20 mm) can be set.
Press the key to move to the next operating mode.
Off:
The print order is processed without cutting.
Without backfeed:
A cut is effected after each label.
We recommend using this operating mode if no data which is to print
is in the upper part of the label.
With backfeed:
A cut is effected after each label.
Interval with final cut:
A cut is effected after a fixed number of labels which you have to enter
at the print start and additionally at the end of the print order.
Interval without final cut:
A cut is effected after a fixed number of labels which you have to enter
at the print start. At the end of the printer order no cut is effected
except when the set interval comes to the end of the print order.
Final cut:
A cut is only effected at the end of the print order.
Operating modes