Carl Valentin C220, Инструкция по эксплуатации

Страница: 6 / 44

Introduction C220 / C300 / C400
6 Service Instructions 03.22
1.2 General Safety Instructions
WARNING!
Danger of injury by inadvertent move out of the cylinder.

Disconnect the printer from the power supply before
mounting the applicator.

Connect the compressed air only after mounting the
applicator to the printer.
•
Only connect the device to other devices which have a protective
low voltage.
•
Switch off all affected devices (computer, printer, accessories)
before connecting or disconnecting.
•
The device may only be used in a dry environment, do not expose
it to moisture (sprays of water, mists, etc.).
WARNING!
In operation, moving parts are easily accessible. This
applies especially for the zone, where the pad is moved
between the starting and the labelling position.

During operation do not reach into that zone.

Keep long hair, loose clothes, and jewellery distant.

Before any manipulations in those areas, close the
shutoff valve.
WARNING!
Other unauthorized work on or modifications to the device
can also endanger operational safety.
Unauthorized interference with electronic modules or their
software can cause malfunctions.

Perform only those actions described in this operating
manual.

Work going beyond this may only be performed by
trained personnel or service technicians.
WARNING!
The drawing in of items of clothing by moving parts can
lead to injuries

If possible, do not wear clothing which could be
caught by moving device parts.

Button or roll up shirt or jacket sleeves.

Tie or pin up long hair.

Tuck the ends of scarves, ties and shawls into your
clothing or secure them with non-conductive clips.