7
AILERON SERVO INSTALLATION
Note:
The following pictures may not exactly match
the hardware you are using. Always check the
radio manufacturer's instructions when installing
radio equipment.
1.
Collect the following items:
(4)Servo mounting screw (supplied with radio)
(1)Servo with rubber grommet (supplied with
radio)
(4) Servo extensions “6”
IMPO
RTANT!
To ensure that any connections locat-
ed inside the wing will not come loose, either when
the wires are pulled, or during flying,
always tape
them securely together with electrical tape.
4.
Making sure to use the correct servo for the
opening, attach the servo wire to the 6" exten-
sion and securely tape the connection.
Locate the string inside the aileron servo
mount, and the other end in the exit hole.The
hole in the top wing is just behind the front
cabane mount, The bottom wing has the hole
in the middle of the center section.
Tie the string to the aileron extension by loop-
ing it through the opening between the wires
on the plug and taping with masking tape.
5.
Grasping the string,
SLOWLY
pull until the
end of the 6" extension comes out of the hole.
Tape the extension securely to the wing, so
that it will not slide back in while you are work-
ing.
Secure servo with the screws supplied with
the radio.
Repeat for the other three wing servos.
AILERON CONTROL HORN INSTALLATION
1.
Collect the following items
(8) 2-56 Golden Clevis
(8) Clevis Clips
(8) 2-56 Hex Nut
(4) 2-56 x 1-3/4” threaded both ends wire
(4) 6-32 x 2” Bolt
(4) 6-32 Hex nut
(4) #6 Washer
(4) 6-32 Horn Bracket
2.
With the aileron servo in place, make a mark
at a 90º degree angle to the trailing edge and
in line with the servo arm.
3
.
Use the mark to locate the hard point installed
in the aileron( dowel with hole in middle).
4.
Using a 9/64" drill bit, open the hole in the
aileron through to the top side.
HINT: Drill the hole from the bottom half way.
Then drill down to the hole from the top of
the aileron.
5.
Insert the 6-32 x 2” screw from the top through
the aileron.
Place the #6 washer and the 6-32 hex nut on
the bolt and tighten. Make sure that you use
thread lock on the bolt and nut.
Screw the adjustable horn bracket on the
bolt.
