7
2.
Remove the covering off the bottom of the
rudder hinge post.
Glue the fin to the fuselage making sure to
keep the fin perpendicular to the stabilize.
Landing Gear
1.
Collect the following parts:
(1) Fuselage
(1) Main Landing Gear Wire
(1) #2 x 3/16” Socket Head Screw
(2) Wheels
(2) Nylon Wheel retainers
(2) Landing gear fairing
2.
Remove the hatch from the bottom of the
fuselage
Insert the landing gear into the slot just in front
of the hatch opening.
Using the #2 x 3/16” screw , insert the screw
into the hole and tighten.
3.
Place the wheel onto the wire and hold it in
place by inserting the Nylon retainer on the
end.
Place a drop of glue on the end of the wire to
hold the retainer in place.
Remove the covering over the rudder control
horn slot.
Glue the Nylon control horn into the slot mak-
ing sure that the rudder control horn is on the
opposite side from the elevator control horn.
3.
Take the long wire pushrod and insert the end
into the pushrod tubing inside the fuselage
next to the servo tray.
Attach the EZ connector to the control horn
with the adjusting screw facing down.
Push the rudder pushrod through the EZ con-
nector and snug the set screw to hold the
pushrod in place
4.
Place the landing gear fairing on the fuselage.
Tape the fairing to the fuselage using the clear
tape provided. Try and keep the fairings paral-
lel to the fuselage centerline.
Do not tape the
fairings to the landing gear.
Tail Skid
1.
Collect the following parts:
(1) Fuselage
(1) Tail Skid
2.
Insert the tail skid wire into the bottom of the
fuselage under the tail in the pre-drilled hole.
Glue the wire in place using epoxy.
