Caretec Zeitgeist 2, Руководство пользователя

Страница: 10 / 35

10
Note: If the display is functioning, but you can't hear anything or very little from the speaker, first
check the volume setting in the Settings menu. Next check whether the grille covering the speaker is
dirty. In extreme cases these little openings become so clogged with dirt that the device needs to be
cleaned by the dealer or manufacturer or the speaker even replaced.
This also applies to the little opening of the microphone if the volume of your voice recordings
comes out very low.
5.1 Home screen
The Zeitgeist 2 is normally in home screen mode, i.e. on standby and awaiting a
command, i.e. for a button to be pressed.
The device will also automatically return to the home screen from numerous sub-menus
if you take no action for a while, around 30 seconds.
If the device goes back to home, you will hear a signal to indicate this.
You can access numerous functions directly from the home screen using quick access :
( Note: Some functions can also be accessed as usual via the main menu; for details see Main menu.)
With quick access, the device once again distinguishes between individual buttons,
combinations of them, and how long they are pressed, SHORT or LONG.
•
Top SHORT ....... To announce the clock time in 24 hour-format with seconds
•
Bottom SHORT . To announce the date in long form, also including the
calendar week and phase of the moon
•
Middle SHORT
... To call up information about the last menu item
executed
(Careful: This may produce confusing results,
depending on the preceding action.)
•
Top+Middle SHORT ....... To announce information about active alarms
• Middle SHORT . To announce information about active calendar entries
•
Top+Bottom SHORT
...... To announce information about battery status
•
Top LONG .......... To make the clock time vibrate according to the widespread
industrial standard, i.e. vibration code with long and short
vibration pulses. Here a long vibration pulse means 4 and a
short one 1, i.e. the number 9 is made up of long-long-short;
for further details see below in section 5.1.1.
The intensity and duration can be changed in the Settings
menu, section 7.10.
•
Bottom LONG .... Starts the Lumitest function
•
Middle LONG ..... To call up the main menu (see section 6)
•
Combination Top+Middle LONG ...... To start or stop automatic time setting
via GPS signal
•
Combination Middle LONG To record a new voice memo
• Combination Top+Bottom LONG ..... To reset the device (RESET)