Carefree of Colorado
Wind Smart
Auto-Retract System
9
052987-002R5
T
ESTING
W
IND
S
MART
O
PERATION
NOTE: These tests will use the WIND
SPEED switch.
H
I
is the least sensitive and responds to winds approximately equal to 12 mph.
M
EDIUM
responds to winds approximately equal to 8mph.
L
OW
is the most sensitive and responds to winds approximately equal to 4mph.
1.
If not previously done, release the anemometer (step 7 above).
2.
Set the M
ODE
switch to WIND SMART ON.
3. Set
the
WIND SPEED
switch to HI.
4.
Extend the awning using the P
ATIO
switch.
5.
Spin the anemometer. The awning should retract automatically to the closed position.
NOTE: Do not hit the anemometer to spin. Using compressed air provides a constant pressure
source and, the output can be regulated to test the various sensitivity settings. D
O NOT
position the nozzle closer than 10 inches from the cups.
STOP
: If the awning does not move or functions differently than described above, set the Mode
switch to the off position. Go to the Diagnostics section on page 12. Restart the tests after
following the steps in the Troubleshooting section.
6.
Repeat steps 3 and 4 two (2) more times with the Wind Speed switch set to MED and then to LOW.
7.
Repeat steps 2 through 4 with the Mode switch set to OFF and POWER ON. The awning should not move.
Table of Contents
