| User Manual - HF0020 Knee Walker
4
Mast Hand Clamp Adjustment
•
The hand clamp located at the base of the steering
column should secure the mast tightly to the frame
so that there is no looseness. The following steps
(if necessary) will allow you to adjust the tightness
of the clamp if you find that it is either is too hard to
push down or too loose to hold the mast securely.
•
Place the clamp in the downward position.
•
Push upward on the clamp until the nut is between
the two sides of the mast platform (see image 7).
•
Turn counter clockwise to loosen the tension on the
clamp or turn clockwise to tighten the tension on the
clamp.
To Lower the Steering Column
(for transport)
•
Pull the clamp arm up to release the clamp and push
the clamp arm forward.
•
Slide the clamp to the right so that the pin
disengages from the mast platform.
•
Gently guide the steering column downward and
position below the seat.
Steering Mast Height Adjustment
•
Remove the triangular adjustment knob by turning
counter clockwise.
•
Adjust the handles to the desired height.
•
Insert the screw into the hole on the mast and tighten
until secure.
Adjusting the Knee Platform
•
The Care Quip Knee Walker can be used for right
or left leg injuries. The offset position of the seat
provides better stability and increased foot clearance
for pushing forward. When standing behind the
scooter, the knee platform should be offset on the
side of the non-injured leg (see image 8).
•
Remove the height adjustment screw from the frame
and then remove the knee pad from it’s upside down
shipped position.
•
Insert the knee post into the frame (see image 9).
•
Adjust kneepad to the desired height and insert the
screw through the frame and into the post and hand
tighten (see image 10).
Image 7
Image 8
Image 9
Image 10
