FOR ALL USERS
Fig a
Fig b
1
Before use, c
heck that the sling is in good condition and
appropriate to the users size.
2
This sling can be fitted in a supine or seated position (as described
below)
FITTING IN A SUPINE POSITION
Position the sling by rolling the user into the recovery position. Always
roll the user towards yourself if possible. Align the sling along their
length and tuck it under them from their back towards their front, until
the longitudinal centre of the sling aligns with the user’s spine. Roll
them back onto a supine position and then into the recovery position
facing the other side of the bed. Carefully pull the sling through
underneath them. Roll them back onto a supine position. Check the
alignment of the sling and reposition if required. Fasten the three
buckles across the chest and tighten using the adjustment straps until
comfortably secure (Fig a). The upper lifting straps should pass over
the users shoulders. Fit the leg sections around the user’s upper leg.
Close and fasten the two outer buckles and tighten using the
adjustment strap until comfortably secure (Fig b).
FITTING IN A SEATED POSITION
Slide the sling down behind the user with the label at the back. The leg
sections should be at the lowest edge. Fasten the three buckles
across the chest and tighten using the adjustment straps until
comfortably secure (Fig a). The upper lifting straps should pass over
the users shoulders. Fit the leg sections around the user’s upper leg.
Close and fasten the two outer buckles and tighten using the
adjustment strap until comfortably secure (Fig b)
3
Final adjustments should be made depending on whether
the sling is to be used for standing (
A)
or access (
B
)
A FOR STANDING
4
Take care that the strap attachment and adjustment is correct for standing (A) and access (B) before hoisting.
The posture and comfort of the user is determined by the adjustment of the straps and positioning of the sling parts.
A
ATTACHMENT AND ADJUSTMENT FOR STANDING
•
Attach only the shoulder straps to the spreader bar. The shoulder straps are adjustable to ensure adequate head
clearance from the spreader bar.
•
Taller users may need the shoulder straps adjusting longer to provide sufficient head clearance.
•
Hoists with limited lift may require the shoulder straps to be shortened to maximise the hoist lift
•
Check the 3 chest buckles are still tightened sufficiently to provide a secure fastening. The torso will extend during
the lift which may require further adjustment.
B ATTACHMENT AND ADJUSTMENT FOR ACCESS
•
Determine the correct loop on the leg strap for the position required. The choice of loop will depend on how reclined
the user will be. Shortening the shoulder strap, or using the shortest leg loop will further the recline. Attach the
chosen loop to the hoist.
•
Lengthening the shoulder straps or choosing the longer leg loop with sit the user more upright.
NOTE: If using this sling for different users without adjusting the straps, the taller and slimmer users will be more reclined and
vice versa.
WARNING: Mobile hoists must have unobstructed movement, with the brakes off when using the HUG Mk2 in
USER GUIDE – GLOVE HUG (MK2) SLING ( LOOP STRAPS ONLY)
(SEE ADDITIONAL SHEET FOR CLIP STRAPS)
This user guide gives basic advice about using the Glove HUG (MK2) sling. It is not a substitute for proper training. If in doubt about any
aspect of sling use, consult your Occupational Therapist, Moving and Handling advisor or another competent person.
Professionals, if in doubt, please contact your supplier.
CE
EU93-42
Manufactured by Care and Independence Ltd.
01869 327999
Put the middle leg strap into the pocket provided to avoid
any hazards taking care to avoid the strap catching on the
hook tape closure (Fig c). Close the pocket using the hook
and loop tape.
B FOR ACCESS
Connect the middle leg buckle by sliding one part through
the other as shown (Figs d,e and f).
Fig d
Fig e
Fig f
