HF3000-Series Installation Manual
Doc. No. Revision
07-0002 Rev.3
Page
8
of
14
© 2018 Cardinal Health. All Rights Reserved. CARDINAL HEALTH, the Cardinal Health LOGO and ESSENTIAL TO CARE are trademarks or registered
trademarks of Cardinal Health. All other marks are the property of their respective owners.
Step 6
Connect network cable to network port on wall, and connect AC power cord to an
electrical outlet on wall. The wall outlet must be easily accessible.
NOTE: If the network cable is not long enough, obtain a longer straight-thru network
cable (a crossover cable will not work). In the final installation the network cable should
not be under physical stress and should not be resting against electrical equipment such
as motors or heating units.
When successfully connected, the cabinet shelf illumination lights, shelf indicator LEDs,
and eBox LEDs will turn on in about one minute. The cabinet is now ready for
configuration.
If this does not occur and power/network connections and sources are confirmed to be
correct and live, contact WaveMark Customer Support via phone at 877.492.8362 or via
email at [email protected]
Step 7
Place cabinet into its final position.
Step 8
Secure cabinet to the wall with the included mounting hardware. See Section 9 for more
information.
8.2 Shelf installation
Step 1
Stabilize cabinet against a wall or equivalent.
Note: If this is the initial installation, remove shelves transported in cabinet and set aside.
Step 2
Use the allen wrench provided with the cabinet to remove the end corner caps by removing
the four screws from each corner cap. Set corner caps aside in a manner that will prevent
them from falling over.
Step 3
Insert Shelf:
1. Orient shelf so the red receptacle is facing out towards front of cabinet and on the right
to be closest to the red network cables.
2. Place shelf in the desired location ensuring that it is aligned in the same numbered
track on each side of the cabinet. Shelf center-to-center spacing should not be less
than 6.5”.
3. Push shelf toward the back of the cabinet until secure.
NOTE:
Only trained technicians should install or adjust shelf location.
The bottom and top shelves must remain in place and should not be moved.
