HF3000-Series Installation Manual
Doc. No. Revision
07-0002 Rev.3
Page
7
of
14
© 2018 Cardinal Health. All Rights Reserved. CARDINAL HEALTH, the Cardinal Health LOGO and ESSENTIAL TO CARE are trademarks or registered
trademarks of Cardinal Health. All other marks are the property of their respective owners.
When entering and exiting elevators, the cabinet’s wheels may lodge in the
elevator door gap. If this happens, gently move the cabinet from side to side and
pull/push to dislodge it. DO NOT USE EXCESSIVE FORCE!
CABINET AND SHELF INSTALLATION PROCESS
8.1 Cabinet Installation
Step 1
Locate power and network cables shipped with the cabinet and remove all packaging
and safety covers.
Step 2
The cabinet network and power connections are located in the base of the cabinet back
panel near the floor.
Step 3
Connect the DC power cable (attached to the power brick) to the cabinet and twist the
connector until secure. This requires several full turn twists until completely tightened.
Connect the electrical AC cable to the power brick.
Step 4
Connect network cable to the back of the cabinet next to the power connector.
Step 5
Tuck power brick into the cavity as shown below:
