HF3000-Series Installation Manual
Doc. No. Revision
07-0002 Rev.3
Page
4
of
14
© 2018 Cardinal Health. All Rights Reserved. CARDINAL HEALTH, the Cardinal Health LOGO and ESSENTIAL TO CARE are trademarks or registered
trademarks of Cardinal Health. All other marks are the property of their respective owners.
7
UNPACKING AND TRANSPORT
NOTE:
Two people are required to move the cabinet from the shipping container to its final location.
Cabinet contains sensitive electronic components. Take care in moving the cabinet from the
shipping container.
7.1 Unpacking the HF3000
Step 1
Prior to unpacking the cabinets, inspect all packing for shipping damage. Take pictures of
any observed damage and immediately report to WaveMark Customer Support toll free at
877.492.8362 or email [email protected]. Include all relevant pictures, a brief
description of damage, as well as cabinet serial number.
Note: Side marked “Ramp” must be facing out with 10ft (3 meters) of clearance to
accommodate ramp and cabinet unloading.
Step 2
Cut and remove strapping. Remove outer layers of packaging and discard. Be careful not
to damage the cabinet when cutting the packaging.
Step 3
Lower ramp:
1. Remove packing foam from ramp.
2. Lift the wooden ramp out of the groove and position ramp by inserting pin on the
ramp into the hole on the pallet. The edge of the ramp should sit flat against the
crate edge.
Step 4
With one person holding each side of the cabinet, guide cabinet down the ramp to the floor.
Step 5
Inspect the cabinet for damage. Take pictures of observed damage and immediately
report to WaveMark Customer Support toll free at 877.492.8362 or email
[email protected]. Include all relevant pictures, a brief description of damage, as
well as cabinet serial number.
Don’t proceed with the installation of any damaged cabinet.
Step 6
If required, clean the cabinet exterior following procedure in Section 11.
