Cardinal Health Alaris 8000 Series, Инструкция по применению

Страница: 249 / 378

Display references throughout this procedure are for
illustration purposes only.
Reference "General Information", "Features and Displays" and
the PC Unit Section of this
DFU
for information on the
following:
• Displays
• Operating Features, Controls, Indicators
The majority of user interface programming is identical for
both
S
p
O
2
Modules.
Programming
Programming
4-5 Alaris
®
System Directions for Use
SpO
2
Modules Section
Monitoring Mode
1. Perform following steps (reference PC Unit Section of this
DFU
, "General Setup and Operation", "Start-Up"):
a. Power on system.
b. Choose Yes or No to New Patient?
c. Confirm current profile or select a new profile.
d. Enter patient identifier, if required.
2. Attach patient cable and sensor (reference “Getting
Started”).
3. Press
CHANNEL SELECT
key.
•
SEARCHING
may appear in Channel Message display
until
S
p
O
2
and pulse readings stabilize (approximately
15
seconds).
• If sensor is not attached to a site,
SENSOR OFF
displays.
• To prevent screen from reverting to Main Display,
press
ENTER
key within
30
seconds after
SPO2
Main
screen displays.
• If sensor is not attached during message display,
module goes into sleep mode. To begin monitoring
once module is in this mode, press
MONITOR
key.
4. Ensure sensor's red
LED
is on.
CHANNEL
SELECT
CHANNEL
OFF
MONITOR
% SpO2
PULSE (BPM)