Cardinal Health Alaris 8000 Series, Инструкция по применению

Страница: 245 / 378

Getting Started
Introduction
Getting Started
4-1 Alaris
®
System Directions for Use
SpO
2
Modules Section
This Section of the Directions for Use (
DFU
) provides Alaris
®
S
p
O
2
Module,
8210
and
8220
Series ("
S
p
O
2
Module"),
instructions and information. It is used in conjunction with the
following:
Alaris
®
PC Point-of-Care Unit ("PC Unit") Section of this DFU
Nellcor
®
and Masimo
®
Cable and Sensor Instructions
Maintenance Software and User Manual for Alaris
®
System
S
p
O
2
Module sensor and cable Compatibility Cards
S
p
O
2
Module Technical Service Manual
The
S
p
O
2
Modules are indicated for continuous, noninvasive
monitoring of functional oxygen saturation of arterial
hemoglobin (
S
p
O
2
) and pulse rate measured by an
S
p
O
2
sensor. The
S
p
O
2
Modules and accessories are indicated for
use with adult, pediatric and neonatal patients during both no
motion and motion conditions, and for patients who are well or
poorly perfused in hospitals and hospital-type facilities. Only
1
S
p
O
2
Module can be connected to the Alaris
®
System.
The
8210
Series
S
p
O
2
Module uses a Nellcor
® DOC-10
patient
cable and a wide variety of O
XI
M
AX
®
series sensors. The
8220
Series
S
p
O
2
Module uses a wide variety of Masimo
®
patient
cables and Masimo
®
sensors. For specific directions for use,
reference the applicable cable and sensor packaging.
The majority of user interface programming is identical for
both
S
p
O
2
Modules. If a procedure/information applies to a
specific module, the following identifiers will indicate the model
it applies to.
8210
Series:
(8210)
8220
Series:
(8220)
Cables and Sensors: Reference "General Information" for
"Cables and Sensors" information.
Read all instructions , for the
S
p
O
2
Modules and PC Unit, before using
the Alaris
®
System.
WARNING
nly
O
CAUTION