•
Figure 10
9
Secure the motor chassis with the two No.10
×
2"
self tapping screws provided (Figure 11).
N.B. On bottom fixing use 1" black spacer insert
provided, to place between chassis plate and frame.
Ensure spacer is correct way round (see Figure 11).
with the screw passing through the spacer.
OPEN/CLOSE DOOR SEVERAL TIMES TO ENSURE
DOOR OPERATES FREELY.
6b
If door is fitted to a Steel frame.
IMPORTANT:
Your CD45/CD PRO framed door must
be fitted correctly in accordance with the framed
door fitting instructions for
behind the brickwork
installation
. Unfortunately Autoglide cannot be
fitted to a CD45/CD PRO framed door fitted between
the brickwork (Figure 10).
i
Close door fully and prop securely in position.
Remove ONE wall fixing bracket from right-hand
frame side channel. Replace removed bracket
with special cut down bracket supplied (parts list
item 12).
ii
Repeat for other right-hand wall fixing bracket.
iii Offer track to right-hand side of door and slide
spindle into shaped recess in top of drive carriage.
Align holes in track with pre-pierced holes in
frame channel.
iv Slide one
*
3
/
16
" washer between channel and
track and align with centre fixing hole. Fix track
to channel using one No. 8
×
1" self tapping screw
provided.
v
Repeat for other two holes in track.
vi Secure the motor chassis by sliding one
*
3
/
16
"
washer under each fixing hole and using the
two No 10
×
2" self tapping screws supplied.
(Figure 11).
N.B. On bottom fixing use 1" black spacer insert
provided, to place between chassis plate and
frame. Ensure spacer is the correct way round (see
Figure 11) with the screw passing through spacer.
OPEN/CLOSE DOOR SEVERAL TIMES TO
ENSURE DOOR OPERATES FREELY.
25 mm
•
Figure 9
Spacer
No.8
×
1”
countersunk
screws
No.10
×
2”
panhead
screws
•
Figure 11
*NOTE:
3
/
16
" WASHERS NOT REQUIRED ON CD PRO
STEEL FRAMES
25mm CD45
6mm CD PRO