23
ii
Operate manual release lever to disengage drive (Section 3.5)
iii Test door operation and correct any binding or out of balance.
iv Re-engage drive (Section 5) and turn power back on.
– Reconfigure power and sensitivity settings (see Section 6a)
5
DOOR CLOSES BUT LATCHES DO NOT ENGAGE
–
Check that drive carriage has been pulled down to its lowest
position (see Figure 12 in Section 4).
–
Check latch cable settings (Section 4.8)
–
Check tilt bracket setting (Section 4.2)
–
Grease latch release cam and pin on drive carriage.
–
Grease latch plates and latch pins on door.
–
Check bottom limit switch has been set low enough to ensure
‘slam action’ of latches.
6
DOOR SHUTS TOO VIOLENTLY OR SHUTS AND THEN OPENS
AGAIN IMMEDIATELY.
–
Adjust the bottom limit switch to a slightly higher position.
7
UNIT FAILS TO OPERATE AND
LED FLASHES ALTERNATE
RED/GREEN.
–
Indicates a limit switch fault:–
i
Switch off power to unit and read safety notes at front of this
manual.
ii
Operate manual release lever to disengage drive (Section 3.5)
and manually move door to half open position.
iii Check operation of both limit switches by depressing the small
plunger pin several times to ensure that it springs back out again,
and that there is an audible ‘click’ from the switch.
iv RE-engage drive (Section 5) and turn power back on.
v
Test operation again.
If L.E.D. still flashes alternate RED/GREEN then a limit switch is
damaged/faulty and will require a service engineer visit.
8
UNIT FAILS TO OPERATE FROM REMOTE BELL PUSH.
–
Check connections to bell push are correct and secure.
–
Check operation of bell push button “makes/breaks” the contacts.
–
Check wiring for damage/breaks and is routed away from any
mains electrical cables.
–
Check connections to 2 way plug in Autoglide unit are correct
and secure.
–
Check 2 way plug is fully engaged into socket in Autoglide unit.