20
9
Fitting the Remote bell push and Courtesy lamp
9a Remote bell push
1
Your Autoglide is supplied with a Bell push so that
you may have REMOTE push button control.
2
Fit the Bell push button in the required location using
the yellow wall plugs and No 4
×
1" screws provided.
Remember to mount at a minimum height of 1.5 metres
(out of reach of small children) and for safety it must be
within sight of the door to be operated, but not within the
area of movement of the door.
3
Use twin core bell wire or telephone cable (not supplied) and
connect the bell push to the green 2 way input plug on the control unit
(see Figure 26).
4
Be sure to route the bell wire away from mains electric cables to
reduce the possibility of electrical interference generating ‘phantom’
signals. Secure bell wire with suitable cable clips.
9b Courtesy lamp (if supplied)
1
Ensure mains power to the Autoglide unit is switched OFF.
2
Fix the courtesy lamp in the position you require, carefully following
the fitting instructions supplied by the lamp manufacturer.
3
Measure the length of cable required to connect the courtesy lamp
back to the Autoglide unit and obtain sufficient cable, which must be to
the following specification:–
3 CORE 3183Y MAINS CABLE .75mm
2
6 AMP
4
Connect one end of the cable to the lamp unit in accordance with
the lamp manufacturers instructions.
IF IN DOUBT CONSULT A QUALIFIED ELECTRICIAN.
Fit 60W MAX GLS bulb to the lamp unit (not supplied)
5
Run the cable back to the Autoglide unit in a safe and professional
manner in accordance with current IEE wiring regulations. Secure cable
with suitable cable clips.
6
Ensure mains power to the Autoglide unit is switched OFF
7
Select the lamp output connector (item 11) from the parts supplied
and using a small electrical screwdriver remove the connector cover by
undoing the central screw.
8
Pass the cable through the shroud and under the cable clamp and
then connect to the screw terminals as per Figure 27.
IF IN DOUBT CONSULT A QUALIFIED ELECTRICIAN
Control box
Green
2 way
plug
1.5 metre
min
Bell push
•
Figure 26