6b Configuring the remote control handset
Ensure that the power switch on the unit is in the OFF position
(see Figure 25)
Plug in the power supply cable (see Figure 25) and turn on at the mains,
but leave the switch on the unit turned off for the moment.
1
Press and hold down the button and turn on the unit
power .
2
Release the button.
3
Briefly press the button again.
4
The LED will light orange.
5
Press either button on the handset. The orange LED will go out.
6
Press either button on the handset again. The orange LED will flash
for approx 10 seconds.
NOTE:
To set up another handset repeat stages 5–6. When you have
finished setting up the handset(s) continue with stage 7.
7
Configuration of handset buttons – with the button released,
press the handset button that you wish to use to operate the door.
The LED should light orange to acknowledge receipt of the signal.
In addition, if the left handset button is pressed the LED will
flash red, if the right handset button is pressed the LED will flash
green.
If you want to change buttons, press both buttons on the handset
simultaneously to reset (The LED will flash orange briefly and the
LED above will flash red then flash green), and then repeat
stage 7.
8
To configure additional handsets also repeat stage 7.
9
Press the button to store your settings.
10
The LED should show green/flashing green, indicating that the
handset(s) have been successfully configured.
16