Caravaggi 20 SP, Инструкция по эксплуатации и обслуживанию

Страница: 9 / 24

4. CORRECT USE OF THE MACHINE
The machine must be run by one operator only.
The operator must be have read and fully understood the instructions in this manual
in order to use the machine correctly.
The operator must be ensure that person or animals do not come within the field of
action while the machine is running.
The Stump-grinder series SP Caravaggi has been built to shred logs and roots of
cut trees in gardens, parks, banks of canals, etc., etc., helping to restore the
landscape.
It is not suitable for chopping products other than those listed above.
To work with other products, contact the machine manufactures or authorised
dealers.
The operator must be aware of all the instructions given in the instruction manual.
5. UNPACKING AND PREPARATION
The Stump-grinder can be arranged on pallets to facilitate handling and transport
before installation, depending on the versions.
To transport the machine in these conditions it is indispensable to use a transpallet
or similar with a load capacity of around 300 kilos.
Avoid:
•
hoisting the stump-grinder with ropes or unsuitable hoists;
•
dragging the stump-grinder;
•
bumps or shocks;
•
exposing the machine to rain, frost or any bad weather.
On taking delivery check that the contents correspond with the delivery note
.Should damage or deformity due to transport be noted, make an immediate
compliant to the carrier and advise the authorised dealer or the manufacturer. In
particular, check that:
•
there are no dents, signs of bumps or deformations;
•
there are no damp areas or signs that may lead to suppose that the pack has
been exposed to foul weather;
•
there are no signs of tampering;
After checking that transport has been carried out correctly, proceed to prepare the
machine as follow :
•
cut sections of packaging, freeing the machine from the pallet.
•
bring the lever of the clutch differential in the OFF position, as shown in Fig. 5.
•
move the machine from the pallet, using the handle to balance and move on
wheels, down from the pallet and being careful not to damage the group of
milling.
•
bring back the clutch lever of the differential in the original position ON, as
shown in Fig. 6.