Carat SL-1255, Инструкции по безопасности

Страница: 34 / 98

34
GB
.....wear safety-approved hard hat
......Keep hands clear – pinching hazard.
DANGER! Keep hands away from cutting area and the
blade.
rotating parts - entanglement hazard. Keep
hands, loose clothing and long hair away
from moving parts
do not dispose of electric tools, accessories and
packaging together with household waste material
......warning of general danger
….class II tool
.......read these instructions
......always wear eye protection
......always wear a dust mask.
.....always wear hearing protection
SPECIFIC SAFETY RULES
1. Keep hands away from cutting area and blade at all times! Keep your second hand on an auxiliary
handle. If both hands are holding the saw, they cannot be cut by the blade.
2. Do not reach underneath the work.
3. Hold tool by insulated gripping surfaces when performing an operation where the cutting tools
may contact hidden wiring or its own cord. Contact with a “live” wire will make exposed metal parts of
the tool “live” and shock the operator.
4. Always use blades with correct size and shape arbor holes. Blades that do not match the mounting
hardware of the saw will run eccentrically, causing loss of control.
5. Never use damaged or incorrect arbor flanges or bolts. The arbor flanges and bolt were specially
designed for your saw, for best performance and safety of operation.
6. Maintain a firm grip on the saw and position your body and arm in a way that allows you to resist
KICKBACK forces. KICKBACK forces can be controlled by the operator, if proper precautions are taken.
7. Do not use a dull or damaged blade.
8. Use only recommended blades, rated at the machine’s maximum rated RPM or higher with correct
arbor hole.
9. Tighten blade retaining bolt and all clamps before operating.
10. Check the inside surfaces of the arbor flanges as well as the sides of the blade for freedom from any
foreign matter.
11. Check the blade for cracks or other damage before operation. Replace cracked or damaged blade
immediately. Carry out a test run without load for at least 30 seconds before use.
12. Never start the tool with the workpiece against the blade.
13. Allow the motor to achieve full speed before cutting.
14. Important: After completing the cut, release power switch and wait for coasting blade to stop
completely before putting the saw down
15. Never operate the tool in an area with flammable solids, liquids, or gases. Sparks from the
commutator/carbon brushes could cause a fire or explosion.
16. There are certain applications for which this tool was designed. The manufacturer strongly
recommends that this tool NOT be modified and/or used for any application other than for which
it was designed.
If you have any questions relative to its application DO NOT use the tool until you have
written the manufacturer and have been advised.
17. Only use the machine for dry cutting in stone, concrete or masonry.