Car-O-Liner CM 181, Инструкция по эксплуатации

Страница: 15 / 84

15
MAINTENANCE
Insufficient maintenance may result in reduced
operational reliability and in lapse of guarantee.
Wire feed unit
This unit must be kept clean with dry, clean, com-
pressed air and maintained regularly in the areas of
the wire drive rolls and capillary tubes, as it is
essential for consistent wire feed, satisfactory weld-
ing results, and a minimum of wear and tear, that the
wire passes through the wire drive system without
any deformation of the wire or the wire drive rolls.
The contact tips must be checked often and changed
if the copper plating of the wire is damaged on its
way through the tips.
Copper dust may prevent free passage of wire
through the torch liner. Check and cleaning of the
capillary tubes and the wire drive rolls is recom-
mended when necessary.
Welding hose
Great care should be taken to ensure that the
welding hose is not overloaded. It should not be
pulled over sharp edges, and heavy machines should
not run over it as this may damage the torch liner.
The torch hose assembly should be dismantled when
necessary and blown out with clean, dry compressed
air. The torch must be disconnected from the
machine during this process.
Welding torch
There are many parts in the welding torch that have
to be cleaned regularly. The main ones are the
contact tips and the gas shroud.
During the welding process, these parts are bom-
barded with spatter that sticks to the shroud. This
may disturb the shielding gas flowing from the gas
shroud down to the molten pool, and must be
removed regularly. The use of MIG SPRAY loosens
spatter.
During the cleaning process, the gas shroud should
be removed. Do not clean by banging or hitting the
torch.
Power source
The rectifier and transformer should be blown out
with dry air occasionally, otherwise the air circulation
will be affected by the dust.
Important!
Make sure that the machine is disconnected from the
mains supply when the power source needs to be
opened for e.g. replacement of control unit.
TROUBLE SHOOTING
Too little welding effect.
The welding seam forms a bead standing proud
of the plate.
1. One of the three fuses in the main switch is not
working. (This applies to three-phase machines
only).
2. The welding voltage is too low.
Switch one setting higher.
The wire feed is blocking.
1. The inlet nozzle and the wire are not in alignment
with each other.
2. The reel of wire is too taut, the wire must come
off the reel evenly.
3. The inlet or contact tip has worn out or is blocked
up.
4. The welding wire is not clean or it is rusty. It
could also be of an inferior quality.
5. The pressure roller has to be tightened.
Spatter.
1. The wire feed is too fast for the voltage setting.
2. Worn out contact tip.
Porous weld. A cone is formed when spot wel-
ding.
1. Insufficient gas - too little pressure or the bottle is
empty.
2. Contact tip is blocked up.
3. Leakage air is pumped in and mixes with the
shielding gas.
The wire keeps sticking in the contact tip and
feeds at slow speed.
1. The damaged wire should be cut off, pulled out
and replaced. The pressure on the wire feed
roller should be checked and adjusted if neces-
sary.
2. Worn out contact tip.
3. Wire feed speed may need increasing.