CAR-connect LDC.22-500, Руководство по эксплуатации

Страница: 48 / 56

Operation
48 41.CC.2210.3042_BA_V00_EN
5.11.4 Inspection and maintenance table
The following table provides information about the inspections and maintenance to be
carried out on the product, the corresponding intervals and the persons authorized to do
so.
Area Activity Person Interval
1 Visual inspection
Check all stickers on the product to ensure that
they are present, legible and not damaged.
Inspect the plastic casing and the handles for
damage.
I W
Inspecting the housing screws
Inspect all screws on the housing, the handle and
the wheels to make sure they are tight and none
are missing.
Tighten the screws if necessary.
HV Y
Replacing product labels
Stickers must be replaced if they are damaged or
insufficiently legible.
Important: Only the manufacturer can replace
the warranty seal!
HV
Replacing the plastic casing
The plastic casing must be replaced if damaged.
CC
2 Visual inspection
Inspect the membrane keypad and the LC display
to ensure they are legible and undamaged.
I W
Replacing the membrane keypad and LC
display
The LC display and membrane keypad must be
replaced if they are insufficiently legible or their
function is impaired.
CC
Function test on EMERGENCY stop button
Test the function of the emergency stop button by
pressing and resetting it (see the “Emergency
stop button” section).
I D
Replacing the emergency stop button
The emergency stop button must be replaced if
its function is impaired.
CC
3 Safety inspection
Inspect the plugs and electrical cables to ensure
they meet electrical safety requirements.
E W