WARNING
Improper safeCAP SC30 assembly!
An improperly assembled or non-functional two-hand control device can
result in death or life-threatening injuries.
4
Select mounting surfaces for the safeCAP SC30 based on the
dimensions and spacing specified in DIN EN ISO 1385:2019.
4
Protect safeCAP SC30 against unintended actuation, for example
SCP-6.
4
Before working on the machine, check safeCAP SC30 for proper
function.
The safety distance between the machine and the two-hand control is
calculated based on the following formula.
S = K (t1 + t2) + C
■
(S)
Safety distance
■
(K)
Expected approach velocity of the human body or body parts. In
accordance with EN ISO 13855:2010
4
Walking speed 1600 mm/s
4
Grasping speed 2000 mm/s
■
(t1)
Time the safety equipment needs to respond.
■
(t2)
Time the machine needs after receiving the safety equipment signal
until the machine stops.
■
(C)
Additional horizontal distance from the danger zone in mm in
accordance with EN ISO 13855:2010
5.1
Install safeCAP SC30
►
Disconnect the system from its voltage supply
and secure it against being switched on again.
►
Clean the area below the switch.
►
Unscrew the lock nuts (1) on the switch.
►
Insert the switch into the prepared Ø 22.5 m
hole and screw the lock nuts back on.
►
Align safeCAP SC30 and tighten the lock
nuts.
Wiring outside of enclosed installation spaces
must be protected against mechanical
safeCAP SC30
Original operating
instructions
1.1
9/25
