CapstanAG PinPoint III ENVELOP, Руководство оператора

Страница: 85 / 128

TM
Troubleshooting
Chapter 8: Troubleshooting
Troubleshooting Charts
Table 1: System Fault Codes
Fault Code
and Message
Fault Cause Correction
Make sure that the system has at
least 12 V.
Note: At 10 V to 10.5 V the reset
will occur.
Fault 1: Reset Brown out reset The system has reset after
a low voltage event.
Do a check of the power
connections for reliable supply.
Fault 2: Reset Watchdog reset The processor got stuck in
a task. Continue operation. If problem
persists, do a Factory Reset.
Upload software to hub. Fault 4: Memory
Fault Internal FLASH
write Fault The hub did not write
correctly to the FLASH
memory
Contact CapstanAG to repair or
replace the hub.
If the system does not operate
correctly, first do a Factory Reset
Upload software to hub.
Fault 7: Memory
Fault EEPROM read
Fault The hub did not read
correctly from EEPROM
memory
Contact CapstanAG to repair or
replace the hub.
If the system does not operate
correctly, first do a Factory Reset.
Upload software to hub.
Fault 8: Memory
Fault EEPROM write
Fault The hub did not write
correctly to EEPROM
memory
Contact CapstanAG to repair or
replace the hub.
Fault 9: Internal
Communication
Fault Processor
to processor
communication
with VCM Port 1 The main hub processor
and VCM 1 port connector
on the hub have stopped
communicating.
If there are any unused VCM
ports on the hub,remove the
VCM harness from the stopped
port and all subsequent ports.
Skipping the stopped port, install
the harnesses to remaining ports
in the same order.
If all of the VCM ports are in use,
contact CapstanAG to repair or
replace the hub.
©
2021 Capstan Ag Systems, Inc.
85
PinPoint
™
III ENVELOP