Capetti Elettronica WSD15TIIDR, Руководство пользователя

Страница: 7 / 11

WSD15TIIDR
User Manual
WA0140E_WSD15TIIDR User Manual_R11
V4.7
CAPETTI ELETTRONICA s.r.l. - Strada Stratta 57
10090 CASTIGLIONE TORINESE - TORINO - ITALY
VAT 04837130014 - Phone 011.981.98.11 - Fax 011.981.98.210
e-mail info@capetti.it - web www.capetti.it
7/11
5. Enrolling the device.
Not necessary if performed in factory before delivery.
Enroll the device to the network referring to the “ WineCap System - User Manual R29 ”. In case the device is already enrolled but in
STANDBY status, a TEST command must be issued (
refer to Picture 8 - Commands table
).
6. Installation procedure.
After installing the basestation in appropriate place in charge, (
refer to “ WineCap System - User Manual R29 ”
), be sure that the device is
enrolled to the basestation and activated.
Head for the environment to be monitored. On the way, to check the quality of the radio coverage, use the " Field Measurer "
function.
This function is activated issuing the TEST (
refer to Picture 8 - Commands table
)command: position the WineCapKey in the spot
indicated in Picture 7 - WineCapKey positioning and wait for two AMBER flashes, then remove the WineCapKey from device. The
" Field Measurer " function lasts enabled for two minutes.
To issue commands to the device, place the WineCapKey where indicated.
Once the WineCapKey is detected, the led periodically emits AMBER flashes with a 2 seconds cadence.
For each flash, a different command is associated; to confirm the command the WineCapKey must be removed from the sensible
area immediately after the number of flashes corresponding at the desired command. The TEST corresponds to the second pulse
and activate the " Field Measurer " function.
The device will give back the radio signal quality through led flashes:
WIRELESS MODE STATUS Table
Flash count - Wireless mode Status/Radio signal quality
5 green flashes Excellent
4 green flashes Good
3 green flashes Fair
2 amber flashes Sufficient
1 red flash Insufficient
1 red flash 2” long
OUT OF RANGE
Network searching
2 red flashes 2” long STANDBY
Short-long-short red
flashes series
FACTORY RESET
Device not enrolled
Optimize reception selecting the best position: small movements can help.
If the signal is absent or insufficient at the install point, a WR12 router should be put between (
refer to “ WineCap System - User Manual
R29 ”
). The WR12 router itself must be located in a position where the signal level is at least sufficient.
The network will reconfigure itself automatically; the signal will be good again when the device synchronizes with the WR12 router .
The link will not be reconfigured until completely lost by the device. Because of this, in some cases it could be necessary to force
the operation. In such cases, put the device in
STANDBY mode, then run the TEST again (
refer to “ WineCap System - User Manual R29 ”
).
NOTE : The display equipped datalogger (
WD04T
) is recommended, to verify the signal quality during devices installation.
Picture 9 - Status table - Radio signal quality