Capetti Elettronica WineCap WSD12T-IIDR, Руководство пользователя, Страница: 5 / 9

WSD12T-IIDR
User Manual
WA0295E_WSD12T-IIDR_User Manual_R05
V4.6
CAPETTI ELETTRONICA s.r.l. - Strada Stratta 57
10090 CASTIGLIONE TORINESE - TORINO - ITALY
VAT 04837130014 - Phone 011.981.98.11 - Fax 011.981.98.210
e-mail info@capetti.it - web www.capetti.it
5/9
For each flash, a different command is associated; to confirm the command the WineCapKey must be removed from the sensible
area immediately after the number of flashes corresponding at the desired command. The TEST corresponds to the second pulse
and activate the " Field Measurer " function.
The device will give back the radio signal quality through led flashes:
WIRELESS MODE STATUS Table
Flash count - Wireless mode Status/Radio signal quality
5 green flashes Excellent
4 green flashes Good
3 green flashes Fair
2 amber flashes Sufficient
1 red flash Insufficient
1 red flash 2” long
OUT OF RANGE
Network searching
2 red flashes 2” long STANDBY
Short-long-short red
flashes series
FACTORY RESET
Device not enrolled
Optimize reception selecting the best position: small movements can help.
If the signal is absent or insufficient at the install point, a WR12 router should be put between (
refer to “ WineCap System - User Manual
R29 ”
). The WR12 router itself must be located in a position where the signal level is at least sufficient.
The network will reconfigure itself automatically; the signal will be good again when the device synchronizes with the WR12 router .
The link will not be reconfigured until completely lost by the device. Because of this, in some cases it could be necessary to force
the operation. In such cases, put the device in
STANDBY mode, then run the TEST again (
refer to “ WineCap System - User Manual R29 ”
).
NOTE : The display equipped datalogger (
WD04T
) is recommended, to verify the signal quality during devices installation.
7. Stand-alone USB datalogger installation.
Install the datalogger in appropriate place.
If the sampling process has not yet been activated you can start it through the WineCapKey .
Bring it closer to the sensitive point, wait for 2 flashes (
TEST
) (
refer to Picture 5 - Commands table
) and remove. The datalogger begins
sampling according to your settings through your PC.
Through the WineCapKey is possible to ask for the current status, bring it close to the datalogger for 1 flash (
STATE
) and remove it.
STAND-ALONE MODE STATUS Table:
Flash count - Stand-alone mode STATUS
1 green flash 2 seconds long ACTIVE
2 red flashes 2 seconds long STANDBY
Sequence of red flashes: short, 2
seconds long, short
FACTORY RESET
INVALID datalogger clock!
PC connection required
Picture 6 - Status table - Radio signal quality
Picture 7 - Stand-alone datalogger status