User Manual of HD-TVI Speed Dome
31
5.
Configure the alarm linkage action.
You can specify the linked action when an alarm occurs.
(1)
Move the cursor to
LINKAGE
and click the
IRIS+
to enter edit mode.
(2)
Click the up and down direction buttons to choose the desired linkage action. You can set
the alarm action as preset from 1 to 8, pattern from 1 to 5, patrol from 1 to 10, panning
scan, tilting scan, panoramic scan, day mode, night mode or none. You can also set the
alarm output for the alarm. Please refer to
Section 3.5.3
for
details.
6.
Configure alarm priority.
Enter the
PRIORITY
menu and set the alarm priority as
HIGH
,
MIDUEM
or
LOW
.
If multiple alarms with different priorities are triggered at the same time, the dome only
responds to the alarm with the highest priority. If multiple alarms with the same priority are
triggered at the same time, then the dome will respond to each alarm according to the defined
alarm sequence.
3.5.2
Configuring Alarm Parameters
Purpose:
You can set the alarm related parameters following below instructions, including linkage action
interval, alarm duration and dome activity resumption.
Steps:
1.
Enter the alarm parameter configuration menu:
MAIN MENUS > DOME SETTINGS > ALARM INPUT
2.
Configure the interval of the alarm sequence.
When more than one alarm of the same priority occurs at the same time, the speed dome will
respond to one alarm first and then respond to the next one after the user-defined interval. You
can set the on
SEQUENCE
submenu
from 1 to 200 seconds.
3.
Configure the alarm rest delay.
If there’s a linkage action has already been triggered by an alarm input, the speed dome will
only respond to the input from the same channel again after the user-defined reset delay time
.
This is the rest time that the speed dome considers an alarm to be active when it’s physically
cleared. You can set the
DELAY TIME
from 0 to 300 seconds.
4.
Resume the dome activity.
You can set
ALARM RESUME
to
ON
to enable the speed dome to resume its previous activity
after the triggered actions finished.
If the speed dome is moving when a linkage action is triggered, it will stop at the current
position and resume from this position after the linkage action finishes.
The speed dome can be configured to resume the PTZ positions, focus and iris value.
Содержание Winic RedLine CT-AP313-IR
Страница 1: ...HD TVI Speed Dome User Manual ...
