Cansec Canlan, Руководство по установке

Страница: 17 / 31

CanLan Page 17 of 31
Installation Manual August 2014 • Rev. 1.2
SERIAL INTERFACE
In this section, select which of the two available serial interfaces will be used
for the connection between the Canlan and the control panel(s).
NOTE : this does not refer to the connection type used to configure the
CanLan.
RS232 Interface . If the CanLan will be
connected to the control panels using an RS232
connector, choose
RS232 Interface . This refers
to the connection type between the Canlan and
the control panels,
not the cable type used to
configure the Canlan.
RS485 Interface . If the Canlan will be
connected to the control panels using an
RS485 connector, choose
RS485 Interface .
Setup
When an operational mode is chosen, the default communication
parameters are set for the selected control panel type. These settings may be
overridden by clicking the
Setup button.
The current communication parameters are displayed in the status bar below
the interface selection buttons for easy confirmation.
SAVING THE SETTINGS
Choose SAVE from the commands at the bottom of the menu screen.
NOTE
: If you used a network connection to configure the CanLan, change
your PC's IP address information back to the original settings.