Canon XF300, Инструкция по эксплуатации

Страница: 192 / 213

Additional Information
192
8
Troubleshooting
CF A
J
CF B / CF B
J
CF A Switched
- This message appears when you use the SLOT SELECT button to switch the CF card slot in use or recording continued
from one CF card to the other.
CF A
J
CF B / CF B
J
CF A Will switch in a moment
- The CF card is almost full so recording will continue on the other CF card in approximately 1 minute.
CF A/CF B Buffer overflow. Recording was stopped.
- The data transfer rate was too high for the CF card in use and the recording was stopped. Use a recommended card
(
0
39).
CF A/CF B Cannot restore
- Could not recover data on the CF card. Save your clips (
0
158) and initialize the CF card (
0
42).
CF A/CF B error
- The CF card cannot be recognized or cannot be accessed. Check that the CF card is inserted correctly and not
malfunctioning.
CF A/CF B Management data is not supported and will be deleted
- This message may appear if you insert into the camcorder a CF card that was initialized by another Canon professional
camcorder. Check the contents of the CF card.
CF A/CF B Management file error Cannot record
- Cannot record because the camcorder cannot write to the file control information. This may occur if the files on the CF
card were accessed using another device. Save your clips (
0
158) and initialize the CF card (
0
42).
• During double slot recording, both “CF A” and “CF B” will appear in the message.
CF A/CF B Media full
- CF card A or CF card B is full so recording will not start. Switch to the CF card in the other CF card slot to record.
CF A/CF B Media is not supported
- CF cards that are less than 512 MB or not UDMA-compatible cannot be used with the camcorder. Use a recommended
CF card (
0
39).
CF A/CF B Number of clips already at maximum
- The CF card already contains the maximum number of clips (999 clips). Replace the CF card or use the CF card in the
other CF card slot.
- Because both CF cards reached the maximum number of clips, double slot recording is not available.
• During double slot recording, both “CF A” and “CF B” will appear in the message.
CF A/CF B Using a card that supports UDMA mode 4 or higher is recommended
- The CF card’s UDMA mode is lower than UDMA4. We recommend using a CF card that with a UDMA mode of at least
UDMA4.
Change the battery pack
- The battery pack is exhausted. Replace or charge the battery pack.
Check data on CF A/CF B Initializing the card is also recommended
- The CF card cannot be used for any of the following reasons.
• A problem has occurred with the CF card.
• The camcorder cannot read the CF card’s data.
• The CF card was initialized using a computer.
• The CF card has been partitioned.
- Save your clips (
0
158) and initialize the CF card (
0
42).
Check the SD card
- The SD card cannot be accessed. Check that the SD card is inserted correctly and not malfunctioning.
- Due to an SD card error, photos cannot be taken or viewed. Remove and then reinsert the SD card or use a different SD
card.
Cover is open
- The CF card slot cover was open when the camcorder was switched to or turned on in mode. Close the cover.
Data on CF A/CF B needs recovering Attempt to recover?
- If data on the CF card is corrupted, such as when the power suddenly turned off while recording, the data must be
recovered. When this message appears, select [Yes] and press SET.
COP
Y