Canon Wireless Transmitter WFT-E6A, Инструкция по эксплуатации

Страница: 15 / 126

15
This section describes the process of following the connection instructions. If an error is
displayed, refer to “Troubleshooting” in Chapter 10 (p.97) and check the settings.
Pressing the shutter button or other camera controls during configuration by the connection
instructions will close the connection instructions. Do not press the shutter button or other
controls until configuration is finished.
On the [ 5 2 ] tab, set [ Auto power off ] to [ Disable ]. If auto power off is activated, the
connection instructions will be closed during the configuration process.
1
Turn the camera on.
2
Display the transmitter menu.
On the camera, press the <
7
> button.
On the [ 5 3 ] tab, select [ Communication
settings ] and press < 0 >.
3
Select [Communication func].
Set [ Communication func ] to [ Enable ], and then
press <
0
>.
X
[ Network settings ] is now available.
4
Select [Network settings].
5
Select [Connection wizard].
X
The [ Select communication method ] screen is
displayed.
X The <
Y
> lamp on the camera starts blinking.
Displaying the Connection Wizard
COP
Y