Canon VB-M640V, Руководство по эксплуатации

Страница: 126 / 287

126
Settings for using IPsec.
Note
If IPsec is used, video transmission performance drops.
IPsec
[IPsec]
Select key settings for using IPsec.
Auto Key Exchange Settings
[IPsec S A Encryption Algorithm]
Select the IPsec SA encryption algorithm.
The specified algorithm will be checked for an applicable encryption algorithm starting from the left.
[IPsec S A Authentication Algorithm]
Select the IPsec SA authentication algorithm.
The specified algorithm will be checked for an applicable authentication algorithm starting from the left.
[IPsec S A Validity Period (min)]
Enter the duration of validity for IPsec SA.
[I S AKMP S A Encryption Algorithm]
Select the SA encryption algorithm for use with auto key exchange protocol IKE.
Set IPsec
[Security] > [IPsec]
Important
• To run this camera with IPsec, the communicating devices and network must be set beforehand. Contact your system administrator for
these settings.
• When connecting with IPsec, set the camera IP address manually.
For IPv4 addresses, use addresses with [IPv4 Address Setting Method] set to [Manual] in [Basic Settings] > [Network] > [IPv4].
For IPv6 addresses, use addresses set with [IPv6 Address (Manual)] in [Basic Settings] > [Network] > [IPv6].
• If the IPsec setting is changed and the camera may become inaccessible from the active web browser, a confirmation dialog box will
appear. Click [OK] to apply the new settings.
If you reboot the camera and cannot connect to the camera from the web browser, any available URI for connecting to the camera will
be displayed in a message.
If you cannot connect to the camera through the displayed URI, contact your system administrator.