Canon VB-H47, Руководство по эксплуатации

Страница: 131 / 195

131
Set the use of HTTP and SNMP servers.
HTTP Server
Set the authentication method and HTTP port number.
[Authentication Method]
Select an authentication method for use by the HTTP server.
[HTTP Port]
Enter an HTTP port number.
[HTTP S Port]
Enter an HTTPS port number.
SNMP Server
Configure the necessary settings to use SNMP.
Note
• The camera information referenced from the SNMP Manager is read-only.
• Use an SNMP Manager that supports SNMP MIB2 (supporting RFC1213).
[Use S NMP v1 and v2c]
If [Enable] is selected, it is possible to use SNMP v1 and v2c to browse the camera information from an SNMP manager.
[Use S NMP v3]
If [Enable] is selected, it is possible to use SNMP v3 to browse the camera information from an SNMP manager.
[Administrator Contact Information]
Enter contact information (e-mail address, etc.) for the administrator of the camera. Setting information can be referenced
by the SNMP Manager.
[Server] > [Server]
Important
• If the setting of [HTTP Port] or [HTTPS Port] is changed and the camera may become inaccessible from the active web browser, a
confirmation dialog box will be displayed. Click [OK] to apply the new setting.
If the camera is rebooted and cannot connect to the camera from the web browser, any available URI for connecting to the camera will
be displayed in a message.
If unable to connect to the camera through the displayed URI, contact the system administrator.