Canon Super G3 FAX Board-AS, Руководство по обслуживанию

Страница: 24 / 73

Menu List
#1 SSSW SW01 error management
SW02 Not used
SW03 set remedy against echo
SW04 set remedy against communication error
SW05 set standard function <DIS signal>
SW06 to SW08 Not used
SW09 set communication result display
SW10 to SW11 Not used
SW12 set page timer
SW13 Display of the screen Settings
SW14 Inch/mm resolution settings
SW15 Not used
SW17 Transmission level setting of modem
SW18 The control of IP supported communication setting
SW19 to SW21 Not used
SW22 Settings of archive send function
SW23 to SW24 Not used
SW25 set report display function
SW26 set transmission function
SW27 Not used
SW28 set V. 8/V. 34
SW29 Not used
SW30 Dial tone detection method switching
SW31 to SW50 Not used
#2 MENU 001 to 004 Not used
005 NL equalizer
006 line monitor
007 transmission level (ATT)
008 V.34 modulation speed upper limit
009 V.34 data speed upper limit
010 to 020 Not used
#3 NUM 001 not used
002 RTN transmission condition (1)
003 RTN transmission condition (2)
004 RTN transmission condition (3)
005 NCC pause time (before ID code)
006 NCC pause time (after ID code)
007 pre-pulse time at time of call
008 not used
009 number of characters in telephone numbers between transmitting and receiving parties.
010 line connection identification time
011 T.30 T1 timer (for reception)
012 not used
013 T.30 E0L timer
014 not used
015 hooking detection time
016 Time until a temporary response is obtained when switching FAX/TEL
017 Pseudo RBT signal pattern ON time
018 Pseudo RBT signal pattern ON time (short)
019 Pseudo RBT signal pattern OFF time (long)
020 Pseudo CI signal pattern ON time
021 Pseudo CI signal pattern OFF time (short)
022 Pseudo CI signal pattern OFF (long)
023 CNG detection level when switching FAX/TEL
024 Pseudo RBT transmission level when switching FAX/TEL
025 CNG monitoring time when the answering phone connection function is set
026 Silent detection level when the answering phone connection function is set
027 preamble detection time for V.21 low-speed flag
028 Off-hook PCB duty settings
029-80 not used
5. Service Mode
19