Canon Super G3 FAX Board-AR1, Руководство по обслуживанию

Страница: 68 / 69

7
7
Installation_Super G3 2nd Line Fax Board-AR1
Installation_Super G3 2nd Line Fax Board-AR1
7-13
7-13
Installation_Super G3 2nd Line Fax Board-AR1 > Operation Setting > Basic Settings
Installation_Super G3 2nd Line Fax Board-AR1 > Operation Setting > Basic Settings
4) Connect the end of the PTT Cable or Telephone Cord to the Modular Jack (LINE 1 and
LINE 2) on the host machine, and connect the other end to the Modular Jack on the wall.
2x
EXT
HAND SET
LINE
LINE
CAUTION:
• When using the "EXT" modular terminal, use a flat-blade screwdriver, etc. to
remove the Modular Spacer located in the modular terminal area.
• Keep the removed Modular Spacer.
• Do not insert a screwdriver, etc. into the modular terminal.
EXT
HAND SET
LINE
LINE
F-7-37
5) Insert the power plug into the power plug outlet, and turn ON the main power switch.
F-7-36
Operation Setting
Type Setting
Select the country/region of the FAX Board in Service Mode: FAX > TYPE > TYPE
This setting performs the parameter settings to match the communication specification of the
country/region.
1) Set the TYPE of country/region to install this machine, and then press OK.
• Service Mode (level 1) > FAX > TYPE > TYPE
2) Confirm that service mode (level 1) parameter below is "0". In the case, parameter is "1",
change to "0.
• Service Mode (level 1) > COPIER > OPTION > DSPLY-SW > SDTM-DSP
NOTE:
To change parameter to "0" makes no show below [Settings/Registration] >
[Preferences] > [Timer/Energy Settings] > [Restrict Auto Reset Time] and auto shut
down is not available.
3) Turn OFF/ON the main power switch to enable this setting.
Basic Settings
NOTE:
When "System Manager Information Settings" is set, be sure to follow the direction of
user administrator in order to log in as an administrator.
In this section, make only minimum settings required for FAX communication.
• User's T elephone Number
[Settings/Registration] > [Function Settings] > [Send] > [Fax Settings] > [Set Line] > [Line 2]
> [Register Unit Telephone Number] > Enter FAX number > [OK]
• Type of Telephone Line
[Settings/Registration] > [Function Settings] > [Send] > [Fax Settings] > [Set Line] > [Line 2]
> [Select Line Type] > Select the line type to connect > [OK]
• Turn OFF/ON the main power switch after setting the user telephone numbers and the type
of telephone line.