3
Turning the Printer ON/OFF of LBP5900
The power switch to turn the printer ON or OFF is located on the right side of the
printer. Be sure to observe the following instructions in order to prevent unexpected
problems.
Turning the Printer ON
In order to use this printer, you should press " " of the power switch to turn the
printer ON. After running a self-diagnostic test on the printer unit and optional
accessories, the printer will be ready to print.
IMPORTANT
•
Do not turn the power ON immediately after turning it OFF. If you want to turn the printer
ON again after turning it OFF, wait at least 10 seconds after turning the printer OFF
before turning it ON again.
•
Be sure to set the paper cassette in the printer before you turn the power ON for the first
time after you install the printer.
NOTE
When turning the printer ON for the first time after installing the hard disk, or when being
malfunction in the hard disk, it takes approx. 60 seconds to be ready to print because of
formatting after turning the printer ON.
1
Press " " of the power switch on the printer.
Содержание Satera LBP-5600
Страница 1: ...Laser Beam Printer User s Guide User s Guide ...
Страница 51: ...50 1 Pull the paper cassette out Pull the paper cassette out until it stops a a ...
Страница 113: ...112 Right side of the ITB unit inside the printer Drum cartridge guides High voltage contacts High voltage contacts ...
Страница 135: ...134 2 Hold the tab on the wasted toner cover and open the wasted toner cover 3 Remove the waste toner container Tab ...