Canon Saddle Finisher-T2, Руководство по обслуживанию

Страница: 179 / 262

Chapter 3
3-77
F-3-313
5) Release the claw [1] of the stack delivery roller rear
side clutch [2] and remove the clutch [2].
6) Remove the E ring [3], washer [4], and bearing [5]
and remove the stack delivery roller.
F-3-314
7) Disconnect two connectors [1] and remove harness
from the clamp and edge saddle [2].
8) Remove two screws [3] and pull out the processing
tray [4] in the paper delivery direction.
When removing parts inside the processing tray,
be careful not to exert force on the aligning plate
(front/rear) or the rear end stopper plate.
F-3-315
3.4.2.11 Removing the Swing
Unit Static Charge Eliminator
0009-3697
1) Remove the screw [1] securing the static charge
eliminator at the center of the swing unit.
2) Remove two screws [2] securing the ground of the
delivery side static charge eliminator.
F-3-316
3) Pull out the static charge eliminator [1] at the center
of the swing unit from the bottom.
4) Remove the four claws [2] securing the delivery
side static charge eliminator and remove the two static
charge eliminators [3].
[3] [3]
[2] [1]
[4]
[2]
[2]
[3] [4] [5] [1]
[4]
[3] [3]
[2]
[1]
[1]
[2]