Canon Saddle Finisher-T2, Руководство по обслуживанию

Страница: 143 / 262

Chapter 3
3-41
tray cable. To prevent the gear phase from shifting
due to the front and rear rails, the tray must be
attached horizontally. Lower the tray [1] to the
position shown in the figure and compare the
heights of the shutter guide top edges [2] with those
of the tray projections [3] at the front and rear to
check that the tray is attached horizontally. If their
heights are not the same, remove the tray and then
attach it again.
F-3-165
3.3.4 Buffer Roller
3.3.4.1
Removing the Front
Door
0009-4458
1) Open the front door [1] and remove the clip [2].
2) Lift the front door [1] to remove.
F-3-166
3.3.4.2
Removing the Escape
Tray Cover
0009-4428
1) Remove four screws [1], open the escape door [2],
and then remove the escape tray cover [3].
F-3-167
3.3.4.3 Removing the Buffer
Roller
0009-4156
1) Remove the buffer roller axis [2] from two arms
[1].
2) Remove two clips [3] and remove two buffer rollers
[4].
[1]
[3]
[2]
[1]
[2]
[2]
[1]
[3]
[1]