Canon Saddle Finisher-AF2, Руководство по обслуживанию, Страница: 211 / 244

Chapter 5
5-49
5.3.2.33 Adjusting Hole Positions in Feeding Direction
0021-5209
Execute this adjustment to adjust the punch hole position at paper edge.
Be sure to execute this adjustment for both the left and the right stopper units
at the same time.
1) Remove the punch unit.
2) Remove the 2 punch stopper units [1].
- 2 screws [2]
F-5-227
3) Remove the spring [1] (1pc each).
F-5-228
4) Loosen the screw [1] to adjust position of the stopper plate [3] by follow-
ing the scale of the engraved line [2].
- Engraved line
[A]: adjustment position at the time of shipment
[B]: not used
[C]: scale for adjustment
1 increment shifts the punch position toward the paper edge by 1mm.
F-5-229
F-5-230
CAUTION: Point to note at installation after the adjustment
Perform installation while pushing the lower area of the stopper plate [1].
(Install with the stopper [2] pushed in the frame)
[1]
[2]
[1]
[A]
[B]
[C]
[1]
[3]
[2]
[2]
[1]