Canon Saddle Finisher-AF2, Руководство по обслуживанию, Страница: 208 / 244

Chapter 5
5-46
5.3.2.31 Changing Lower Delivery Mode
0021-1764
Execute this adjustment to support lower tray delivery issue of unstapled pa-
per.
Adjusting method is as follows:
1) Turn ON the power of the finisher.
2) Turn ON the power switch of the host machine to be on standby.
3) Open the front door and put the door switch tool into the door switch [1].
F-5-216
4) Remove the screw [2] to remove the switch cover [1].
F-5-217
5) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
F-5-218
6) Press switch SW385 [1] so that this adjustment is ready now.
F-5-219
7) Press push switch SW384 [1] to execute setting.
- 0: Normal mode
- 1: Forcible 1 sheet through delivery mode (all)
- 2: Forcible stack delivery (with buffer) mode (alignment is not
performed)
- 3: Forcible stack delivery (without buffer) mode (alignment is
performed on the process tray)
- 4: Forcible 1 sheet alignment delivery mode (alignment is performed on
the process tray with 1 sheet)
- 5: Forcible 1 sheet through delivery mode (plain paper only)
F-5-220
8) Press switch SW385 [1] again to complete this adjustment.
[1]
[2]
[1]
MEMO:
Under normal circumstances, coated paper is delivered after having been
aligned on the process tray while normal paper is passed through to be
delivered.
However, 1 sheet of coated paper is passed through to be delivered.
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]