Canon Saddle Finisher-AF2, Руководство по обслуживанию

Страница: 193 / 244

Chapter 5
5-31
F-5-132
8) Press switch SW385 [1] again to complete this adjustment.
F-5-133
5.3.2.20 Adjusting Paddle Height
0021-1728
This adjustment is to be executed if any of followings occurs; tray stack fail-
ure due to thin paper, staple alignment failure or replacement of EEPROM
(IC107) on the finisher controller PCB.
F-5-134
1) Turn ON the power of the finisher.
2) Turn ON the power switch of the host machine to be on standby.
3) Open the front cover and put the door switch tool into the door switch [1].
F-5-135
4) Remove the screw [2] to remove the switch cover [1].
F-5-136
5) Set DIP SW382 [1] on the switch PCB as shown in the figure below.
F-5-137
6) Press SW385 [1] so that the height adjustment for the paddle is ready now.
F-5-138
7) Pressing switch SW383 [1] or SW384 [2] determines adjustment level.
By pressing SW383 once, the LED [3] indicates "-1" and the paddle
position [4] is moved down. In the same way, by pressing SW384 once,
the LED [3] indicates "+1" and the paddle position [5] is moved up.
In the case of using thin paper, perform adjustment in the direction to
increase height of the paddle position (+ direction).
- Adjustment range: +12 to -2 (0.1mm-change per unit)
[4] [5]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
[1]
[2]
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]
SW382
SW381
SW383
(-) (+) ENTER
SW384 SW385
DSP381
[1]